Victor Holdfast Rat Traps M200 - 1 Case / 12 Traps -- $24.98

Victor Rat Trap Instructions

Victor Rat Traps M200

Victor Rat Trap M200 is made from FSC certified wood. The snap wire part of the Victor Rat Trap M200 is strong enough to break your finger. Rats are naturally curious so if you place a piece of bait on top of the metal triggering ones it will trap your rodent at that point.

When placing the trap make sure its perpendicular to the wall, so that the trigger end is towards the wall on the hard surface.

Victor Rat Trap M200 is made with FSC certified wood. The original wood-based snap trap is wired with the metal bait pedal. Place sticky bait (i.e. peanut butter) inside the curl found at the end of the bait pedal. Place the traps perpendicular to the wall, so that the trigger end is towards the wall on a hard surface.

It is important to set the trap in an area with a lot of mice activity, for instances, areas where you see a lot of droppings, urine stains, rub marks, etc. Place as many traps as possible, making the traps seem like part of the atmosphere, to bring out best results. One the tricks you could try is to make rodents friendly with these traps, placing unset traps out for about a week with bait on it then setting the trap later will increase your opportunities. It is suggested not to set the traps on machinery surfaces that can vibrate and release the traps. Caution should be taken when using around children or pets--the snap is very strong and could cause bodily injuries.